Table of Contents
Advertisement
Others
Troubleshooting (Continued)
Symptom
Unable to perform camera control
or settings acquired are incorrect
for a span of about 60 seconds
after turning on the power.
Video images cannot be displayed
smoothly.
Forgotten the password upon
enabling the password protection
feature.
Camera turns to another direction
upon initializing.
Unable to select position.
Video images are not displayed.
Delay in the camera's Pan/Tilt
actions.
116
Causes/Remedial Actions
● About 60 seconds are required for initialization of the
camera to complete upon turning on the power.
To perform camera control or acquire settings, do so by
allowing an interval of at least 60 seconds after turning on
the power.
● Live images may appear in slow motion or loss of frames
may occur when the PC specifications or network
bandwidth is inadequate.
● Repair services will be required to undo the password
protection feature. Please consult your dealer for details.
Please also note that you may be asked to produce
identification cards for security reasons.
● Has the Home position been registered?
Register accordingly if this has not been done.
☞
(
Pages 68, 99)
● Are the positions registered?
Register positions accordingly if this has not been done.
☞
(
Pages 68, 99)
● Is the camera connected to a DC 12 V power supply?
Check connection of the Converter Unit. (
● Is the LAN cable connected?
Check connection of the LAN cable. (
● Is the Pan/Tilt speed set to a small value?
Set this to a larger value. (
☞
Page 19)
☞
Page 17)
☞
Pages 71, 98)
Advertisement
Table of Contents
