JVC HM-DSR100RU Instructions Manual page 88

User and
Installation Guide
4. Press the Up or Down
the next code. The
and the Up arrow button scans forward.
When the correct code is reached, the equipment
(whether VCR, TV, or other) powers OFF.
5. Press the
Address
If the code is valid for your remote, the mode light blinks
three times.
6. Power the equipment back ON.
7. Try some other functions to make sure you have the
correct code. Occasionally the
work when others do not.
8. If the other buttons work, do the procedure in the
following section.
9. If the other buttons do not work, power the equipment
back on and repeat steps 2 through 7. The scan resumes
from the last code stored.
The mode light flashes rapidly when the scan has
returned to the starting point and all codes have been
tested for that equipment.
Remember that the remote may not control some
Note:
equipment models.
Page 4-42
arrow button to set the remote to
Down arrow button scans backward,
button to store the code in the remote.
function may
Power
ADDRESS