JVC HM-DSR100RU Instructions Manual page 160

User and
Installation Guide
8. Loosen the elevation bolts and the pivot bolt
just enough to be able to move the support
bracket. Slowly move the dish up and down
until you find the strongest signal. Tighten the
elevation bolts and pivot bolt just enough so
the dish cannot be moved vertically.
9. Repeat steps 7 and 8 until the
displayed, and you have gained the strongest signal possible.
Note: Move the dish slowly from side to side, or slowly up and down, not both at
one time. Loosen the bolts before each movement, and tighten them again before the
next movement.
10.Press the remote control
menu.
The recorder will display an
complete. Select the
The recorder will display a
load") of important system information to the recorder. Follow the direction in the
message, not to disturb or unplug the recorder during the download.
When the download is done, the recorder will briefly display an
message. Then, the recorder should display the Preview Channel,
Satellite Signal
which tells you about available programs, channels, and services. This indicates that
you have properly aimed the dish.
11.Tighten all the bolts to prevent movement of the satellite antenna.
12.Mark the final locations on the mast and mounting bracket with a permanent marker.
This assists you later if you have to realign the antenna because of movement due to
wind or weather.
Do not scratch the painted surfaces to mark them. This will cause rusting.
Note:
Page 7-14
Signal Strength
button to exit the
View
message asking whether the installation is
Attention
option.
Yes
message during satellite transmission ("down-
Warning
bar is green, the word "Locked" is
Point Dish and Signal Strength
Attention: Acquiring
Pivot
Bolt
Elevation
Bolts
(1 on each
side of
bracket)