Event Timers - JVC HM-DSR100RU Instructions Manual

User and
Installation Guide
E T
VENT IMERS
Event timers are a kind of alarm clock, reminding you when a program you want to watch is
about to start. You may set three types of event timers:
VCR Event Timer
Auto-Tune Event Timer
Reminder Event Timer
Before you can use a VCR Event Timer, you must do the following:
Insert a rewound tape on which you want to record.
Use a D-VHS tape if you wish to make a bit stream (D-VHS) recording of
a program. Using a regular VHS tape will automatically record the
program in the analog VHS mode.
If an event time changes by more than twenty-four hours from the
originally scheduled time, the event timer does not execute.
In general, you cannot set an Event Timer for a program on channels 000
through 099. Channel 000 is reserved for input from another auxiliary device.
Channels 001 through 099 are reserved for your local broadcast or cable
stations. The title, start and end times for programs on these stations are
usually not available; this is why the
"Local Programming."
However, suppose you add broadcast channels to the
these channels to a channel number between 001 and 099, and assign them an
ABC, CBS, or NBC network affiliation. The
automatically displays "prime time" program information for the networks. In
this case, you can set an Event Timer for a program on one of these channels.
Page 5-22
This timer does all of the above, plus it starts the built-in
VCR recording the event.
This timer reminds you that the event is about to start,
and changes the channel to that event when it begins.
This timer reminds you that the desired event is about to
start.
Program Guide
displays only the words
Program Guide
Program Guide then
, assign