JVC HM-DSR100RU Instructions Manual page 151

11.Thread the LNBF cable into the cable hole near
the mast foot, up the mast and out the top of
the mast.
Do not kink or pinch the cable.
12.Take the end of the cable coming out the top of
the mast, and thread it up the support arm.
13.Loop the end of the cable over the pivot bolt.
14.Bring the cable back down on the outside of
the mast sleeve, between the dish supports.
15.Thread the cable through the arm and out the
end of the arm.
16.Adjust the cable so that there are about 2
inches of cable out the end of the arm.
17.Attach the LNBF to the coaxial cable(s).
18.Fit the LNBF into the dish support arm, sliding
it in until it is inserted firmly. You may have to
adjust the cable, pulling it back gently through
the support arm.
19.Attach the LNBF to the support arm, using the
LNBF screw and washer.
Installing and Wiring Your System
Installing the Satellite Antenna
2"
Dish
Support
Arm
Mast
RG-6
Hole
Coaxial
Cable
Cutaway View
(dish omitted
for clarity)
LNBF
Connector
Cutaway
View of Arm
LNBF
Connectors
Coaxial
Cable
Washer
Screw
7
Cable
Loop
Pivot
Bolt
Mast
Sleeve
Direction
to Thread
Coaxial Cable
Mast
Foot
Coaxial
Cable
Cutaway
View of Arm
Cutaway
View of Arm
Page 7-5