Clarion VRX93SVD Owner's Manual page 22

Basic Operations
• To prevent the battery from going dead,
operate this unit with the engine running,
if possible.
• When the liquid crystal panel is operat-
ing, be careful not to get your hand or fin-
ger caught between the panel and main
unit or the instrument panel of the car.
Standing up the liquid crystal panel
1. Press the
[OPEN]
button and the liquid crys-
tal panel comes out and stand up automati-
cally.
' ; ' While the liquid crystal panel is opening or
closing, the
LED
of the [FUNC] button blinks.
NOTE:
t'J
If the liquid crystal panel stops in the middle of its
operation, press the [OPEN] button to house the
panel and press the button again to stand it up.
The unit enters the same display mode as the dis-
play was turned off the last time.
22
VRX935VD
Adjusting the angel, etc. of the
liquid crystal panel
The angle of the liquid crystal panel or protrud-
ing amount of the panel from the mounting sur-
face can be adjusted depending on the mount-
ing angle of the unit or light coming into the car.
• To adjust the angle
1. Every time the [TILT] button is pressed, the
liquid crystal panel tilts forward or backward
at up to about 20 degrees. The adjusted an-
gel is stored in memory.
___?QO
~--;
.;;;;
,
//~7
;/' ,/
/' ,I
Ii /
I ;
;
;
;
NOTE:
• 00 not move the liquid crystal panel by hand.
• To adjust the slide position
1. Press and hold the [TILT] button and release
when a beep is heard.
The liquid crystal panel slides forward or
backward. The adjusted slide position is
stored in memory.
There are 3 adjustable positions available on
this panel.
Housing the liquid crystal panel
1. Press the
[OPEN]
button and the liquid crys-
tal panel is housed automatically.
NOTE:
• When leaving this unit unused for a long period of
time or leaving your car, be sure to house the liq-
uid crystal panel into the main unit.