Rear Panel Assembly; Lcd Assembly - Sony PMW-EX30 Service Manual

2-3. Rear Panel Assembly

1. Remove the U case. (Refer to Section 2-1.)
2. Disconnect the fl exible fl at cable from the connector
(CN4) on the CP-400 board.
3. Remove the seven screws, then remove the rear panel
assembly.
4. To install, reverse the removal procedure.

2-4. LCD Assembly

1. Remove the U case. (Refer to Section 2-1.)
2. Remove the front panel assembly.
(Refer to Section 2-2.)
3. Remove the two volume knobs and four screws (PTP3
x 6), then remove the front frame assembly.
4. Remove the four screws (PTP2 x 5), then remove the
LCD gasket and LCD assembly.
5. Disconnect the harness from the LCD assembly.
6. To install, reverse the removal procedure.
2-2
Flexible flat cable
Front frame assembly
LCD assembly
LCD gasket
Volume knobs
Front panel subassembly
B3 x 6
Rear panel assembly
CN4
CP-400 board
PTP2 x 5
PTP
PTP2 x 5
3 x 6
Harness
PMW-EX30