Rear Master Cylinder Reassembly - Suzuki RM125 Owner's Service Manual

15-16 FRONT AND REAR BRAKES
• Set the brake hose end between the hose stopper, then
tighten the brake hose union bolt 2 to the specified torque.
 Brake hose union bolt: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
• Refill brake fluid and bleed air from the brake system.
(15-3)

REAR MASTER CYLINDER REASSEMBLY

Reassemble and remount the master cylinder in the reverse
order of removal and disassembly. Pay attention to the following
points:
• Apply grease to the contact point between piston and push
rod.
 99000-25010: SUZUKI SUPER GREASE "A"
• Set the brake hose end between the hose stopper, then
tighten the brake hose union bolt 1 to the specified torque.
 Brake hose union bolt: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
• Tighten the master cylinder mounting bolts 2 to the specified
torque.
 Master cylinder mounting bolt:
• Install the master cylinder rod pin.
Improper brake hose routing can damage the brake
hose.
Set the brake hose so it touches the stopper and
tighten the union bolt. Ensure the brake hose has
enough clearance to the rear suspension spring.
• Refill brake fluid and bleed air from the brake system.
(15-3)
(or equivalent grease)
10 N·m (1.0 kgf-m, 7.0 lb-ft)
CAUTION