Cautions In Servicing; Connector; Coupler; Semi-Conductor Equipped Part - Suzuki RM125 Owner's Service Manual

13-2 ELECTRICAL SYSTEM

CAUTIONS IN SERVICING

CONNECTOR

• When connecting a connector, be sure to push it in until a
click is felt.
• Inspect the connector for corrosion, contamination and break-
age in its cover.

COUPLER

• With a lock type coupler, be sure to release the lock when dis-
connecting, and push in fully to engage the lock when con-
necting.
• When disconnecting the coupler, be sure to hold the coupler
itself and do not pull the lead wires.
• Inspect each terminal on the coupler for being loose or bent.
• Inspect each terminal for corrosion and contamination.

SEMI-CONDUCTOR EQUIPPED PART

• Be careful not to drop the part with a semi-conductor built in
such as a CDI.
• When inspecting this part, follow inspection instruction strictly.
Neglecting proper procedure may cause damage to this part.

USING THE MULTI-CIRCUIT TESTER

• Properly use the multi-circuit tester + and - probes.
Improper use can cause damage to the motorcycle and
tester.
• If the voltage and current values are not known, begin mea-
suring in the highest range.
• When measuring the resistance, make sure that no voltage is
applied. If voltage is applied, the tester will be damaged.
• After using the tester, be sure to turn the switch to the OFF
position.
 09900-25008: Multi-circuit tester set

Before using the multi-circuit tester, read its instruction manual.

SWITCH

• Never apply grease material to switch contact points to prevent damage.
Multi-circuit tester set
Click
Click