Sony BVP-900 Series Product Information Manual page 77

WF MODE (waveform monitor mode) connector (4-pin):
Connects to the corresponding connector on a waveform
monitor to allow the sequential monitoring of signals.
PIX (picture monitor output) connector (BNC type):
Supplies a video signal, or video with character signals,
to a picture monitor. Use the PICTURE MONITOR
button on the MSU-700, the MONITOR SELECT button
on the RCP-740/741 or the MONITOR SELECT control
on the BKP-5973 (optional CCU-550/550P Front Panel)
to select the signal output from the PIX connector. When
the signal output from the PIX connector on the RCP-
740/741 or the BKP-5973 is changed, the waveform on
the waveform monitor also changes.
5) SERIAL OUTPUT (serial digital video/audio output) connectors
(BNC type)
Supply the video/microphone signals from the camera in serial
digital format. These connectors are active only when the optional
BKP-5972 SDI Output Board is attached to the CCU-550/550P.
Connect to a digital video switcher or component digital VTR.
6) MIC REMOTE (microphone remote control) connector (D-sub,
15-pin)
Connection for an external control unit, from which the microphone
input levels of the camera can be set to -60, -50, -40, -30 or -20 dB. You
can also set these microphone input levels with the switch on the
Internal power switch and internal boards
1) Internal power switch
When an abnormality has occurred and power cannot be cut off by
pressing the POWER switch on the front panel, open the front panel
and turn off this power switch.
2) Internal boards
Refer to the system manual.
Self-Diagnostics
When an RCP-700 Series Remote Control Panel is connected to the
CCU-550/550P, this control panel can initiate the display of the
internal AT board of the CCU. For details on setting the microphone
input levels with the internal switch, refer to the system manual.
7) INTERCOM/TALLY/PGM (program audio) connector (D-sub,
25-pin)
Inputs/outputs intercom, tally and program audio signals. Connects
to an intercom, tally or program audio connector of an intercom
system.
8) RCP/CNU REMOTE (remote control panel/camera command
network remote) connector (8-pin)
Connects to an MSU-700 Master Set-up Unit, CNU-700/CNU-500
Camera Command Network Unit or an RCP-700 Series Remote
Control Panel with an optional CCA-5 connecting cable to
transmit/receive control signals. When the remote control panel is
connected, it is powered through this connector.
9) COAX (coaxial) connector (BNC type)
Accepts and supplies signals from/to the camera according to the
setting of a switch on the internal DM board. Power is not supplied
to the camera through this connector. Connect a coaxial cable from a
camera to this connector.
10) AC IN (AC power input) connector
Connects to an AC power source using the supplied AC power cord.
Secure the power cord to the CCU-550/550P using the supplied plug
holder.
2
AD
AT
POWER CABLE
ALARM
CAM
OPEN
MAIN
VA
SHORT
NCOM MIC ON - PROD
AU
PREV
OFF
PGM PGM
DM
Internal power switch
1
results of self-diagnostics of the CCU internal boards.
Self-diagnostics of the camera system
The results of self-diagnostics of the camera system are displayed on
three pages superimposed on the CCU monitoring output.. To
display the results, press the CHARACTER button on the RCP-700
Series Remote Control Panel. Press the CHARACTER button again to
display successive pages.
Location and Function of Parts and Controls
Internal boards
10
76