Rack Mounting Of System Equipment - Sony BVP-900 Series Product Information Manual

2
A TOTAL SYSTEM
so that it can be seen even when not looking at the viewfinder
screen. It can be masked with a sliding cover
* Supplied with an external microphone
Photo 2-3 BVF-C10W
BVF-20W(NTSC)/20WCE(PAL) — Electronic Black and White
CRT Viewfinder
* 2-inch 16:9 widescreen B/W CRT viewfinder
* High resolution — 600 TV lines at center in both 16:9 and 4:3
modes
* Diagonal size is 1.5-inch in 4:3 mode and 2.0-inch in 16:9 mode to
ensure easy focusing even in 16:9 mode
* Removable eye-piece allows direct view of the LCD
* Tally lamp for camera operator is located on the viewfinder body
so that it can be seen even when not looking at the viewfinder
screen. It can be masked with a sliding cover
* Removable eye-piece allows direct view of the LCD
* Supplied with an external microphone
Photo 2-4 BVF-20W/20WCE
BVF-10(NTSC)/10CE(PAL) — Electronic Black and White CRT
Viewfinder
* 1.5-inch 4:3 standard B/W CRT viewfinder
* High resolution — 600 TV lines at center
* Diagonal size is 1.5-inch to ensure easy focusing
* Tally lamp for camera operator is located on the viewfinder body
so that it can be seen even when not looking at the viewfinder
screen. It can be masked with a sliding cover
* Removable eye-piece allows direct view of the LCD
* Supplied with an external microphone
Photo 2-5 BVF-10/10CE
13

2-8. Rack Mounting of System Equipment

(a) 19-inch size equipment
The CCU-700A/700AP Camera Control Unit, CNU-700 and CNU-500
Camera Command Network Units, and VCS-700 Video Selector can
be mounted in a 19-inch standard EIA rack. These units either mount
directly into the rack or with optional slide rails such as the Sony
RMM-30 Rack Mount Rail. These slide rails allow the unit to be
easily pulled out from the rack and are recommended if you intended
to pull out the unit frequently.
Warning for Safety Purpose: It takes two or more people to mount a
unit into a rack. Mounting the unit into a rack by yourself can cause
back or other injuries.
Mounting the unit directly to the rack
Fix the unit to the rack using the rack mount bracket of the unit.
Daily maintenance is easy with the unit mounted with this method.
Universal-type rack
12.7
15.9
15.9
12.7
Wide-type rack
12.7
31.75
12.7
Mounting the unit using the RMM-30 Rack Mount Rail
When the RMM-30 Rack Mount Rail is used, the unit can be
mounted into a rack with a depth of 660 to 830 mm (26 to 32 3/4
inches). Proceed as follows:
1: Pull out inner member while pushing against the stopper
Stopper
Inner member
2: Secure the inner members to both sides of the unit with the
screws (+B4 x 8). Use the screws removed from or supplied
with the unit
Outer member