Sony BVP-900 Series Product Information Manual page 76

10
Location and Function of Parts and Controls
Rear Panel
1 CAMERA connector
CAMERA
MIC OUTPUT
CH-1
MIC REMOTE
6 MIC REMOTE connector
1) CAMERA connector (triax connector)
Connector for the triax cable to the CA-550/550P Camera Adaptor
attached to the BVP-950/550 Camera.
2) MIC (microphone) OUTPUT connectors (XLR 3-pin)
Outputs the microphone signals from the camera.
3) INPUT connectors
REFERENCE INPUT loop connectors (BNC type): Accepts
a reference signal (black burst signal) for external
synchronization.
RET1/RET2 (return video signal 1/2) loop connectors
(BNC type): Accepts a return video signal from two
different sources. To select RET 1, press the RET button
on the camera lens; to select RET 2, press the VTR
button on the camera lens.
PROMPTER/RET3 (return video signal 3) loop
connectors (BNC type): Accepts a teleprompter signal
or a return video signal. Use the switch on the internal
DM board to select PROMPTER or RET 3. You can also
select RET 3 by simultaneously pressing the RET and
VTR buttons on the camera lens or using external
controls (such as a pan bar box). For details on the
internal boards, refer to the system manual.
4) OUTPUT connectors
Y/G, R-Y/R, B-Y/B (component video signal output/RGB)
75
MIC OUTPUT connectors
2
3 INPUT connectors
INPUT
Y/G
REFERENCE
RET1
R-Y/R
RET2 B-Y/B
CH-2
PROMPTER/RET3
PIX
INTERCOM/TALLY/PGM
INTERCOM/TALLY/PGM connector
7
4 OUTPUT connectors
OUTPUT SERIAL OUTPUT
VBS3 VBS1
VBS2
WF
WF MODE
COAX
RCP/CHU
REMOTE
9 COAX connector
8 RCP/CNU REMOTE connector
connectors (BNC type): Output component signals or
RGB signals for a chroma keyer. Use the switch on the
internal VA board to select the type of signals to be
output. For details on the internal board, refer to the
system manual.
VBS/1/2/3 (composite video signal 1/2/3 output
connectors (BNC type): Ouput the signal from the
camera in composite format. Use the switch on the
internal VA board to select the composite video signal or
sync signal output from the VBS 3 connector. When the
sync signal (0.3 Vp-p, 75 ohms) is selected, connect the
VBS 3 connector to the sync input of a waveform or
picture monitor.
WF (waveform monitor output) connector (BNC type):
Supplies a video signal to a waveform monitor. The
WAVEFORM MONITOR button on a MSU-700 Master
Set-up Unit, the MONITOR SELECT button on the RCP-
740/741 Remote Control Panel or the MONITOR
SELECT control on the BKP-5973 (optional CCU-
550/550P Front Panel) selects the signal output from the
WF connector. Changing the signal output from the WF
connector on the RCP-740/741 or the BKP-5973
simultaneously changes the picture on the picture
monitor.
5 SERIAL OUTOPUT connectors
10 AC IN connector