Sony BVP-900 Series Product Information Manual page 63

36)PGM (program audio level) control
* Adjusts the output level of the program audio.
* This control adjusts the level of the playback audio signal of the
VTR when the BVP-900/900P is used as a stand-alone camera.
Rear Panel of the BVP-900P
For details on the functions of the switches and controls numbered
1) through 30), see 'Rear panel of the BVP-900'.
TRACKER ENG
INTERCOM 1
37
INTERCOM connector
38 TRACKER control
39
ENG control
37) INTERCOM connector (XLR 5-pin)
* Connection for a headset with an XLR 5-pin connector. The left
INTERCOM connector can be used for communication even if
the power to the camera is turned OFF on the CCU-700P. You
can use the right INTERCOM connector for an RTS intercom
system by installing an optional BKP-7913 RTS Intercom System
Kit. Two RTS belt packs can be connected.
* Playback audio from a VTRs can be monitored via this connector
when using a BVP-900P as a stand-alone camera.
38) TRACKER control
Adjusts the level of the intercom with the tracker.
39) ENG (engineer line) control
Adjusts the level of the intercom with the engineer.
40) MIC (microphone line select) switch
Selects the line to which the headset microphone is connected.
ENG: connected to the engineer's line.
OFF: microphone switched off.
PROD: connected to the producer's line.
41) PROD (producer) control
Adjusts the intercom level of the producer's line.
42) PGM (program audio level) control
* Adjusts the level of the program audio fed to the headset.
* This control adjusts the level of the playback audio from a VTR
when the BVP-900P is used as a stand-alone camera.
1
MIC
PROD PGM
INTERCOM 2
37
INTERCOM connector
42
PGM control
41
PROD control
40 MIC switch
Location and Function of Parts and Controls
10
62