Sony BVP-900 Series Product Information Manual page 104

10
Location and Function of Parts and Controls
this button is not operative.
2) IRIS RELATIVE button
Functions the same as the RELATIVE button of the RCP-730. When
the IRIS/MB ACTIVE button is illuminated, the iris adjustment mode
can be selected with this button. Press and illuminate the button for
Relative mode or press so that the illumination is turned off for
Absolute mode. When the IRIS/MB ACTIVE button is not
illuminated, Relative mode is automatically selected and this button is
not operative.
3) IRIS display
Displays the f number of the current iris setting. When the iris is
closed, 'CL' is displayed.
The items 4) through 9) are the same as those shown for the RCP-
730.
10) IRIS control
The iris control joystick lever (RCP-730)/control knob (RCP-731)
controls the lens iris setting. When the AUTO button is not
illuminated, full manual control of iris is provided. When the AUTO
button is illuminated, the lens iris can be trimmed over +/-2 f stops.
Depressing the joystick lever (RCP-730)/preview button (RCP-731)
provides the camera preview signal at the preview output.
See the table 'Iris adjustment functions'.
11) Iris gauge
The white line on the gauge provides a click position for the IRIS
control. Turn the gauge to set the line to the most frequently used
iris position, and it can be used as the reference for manual iris
adjustment. The gauge rotates infinitely in either direction. When no
click position is required, set the line outside the rotation range of
the IRIS control.
12) MASTER BLACK display
Displays the current master black setting over the range from -99 to
+99.
13) MASTER BLACK control
Manually adjust the master black level. The setting is displayed in
the MASTER BLACK display.
14) PREVIEW button
Connects the preview signal to the PREVIEW connector.
Connector Panel
REMOTE
CCU/CNU AUX
2
AUX REMOTE connector
1
CCU/CNU REMOTE connector
1) CCU/CNU REMOTE (camera control unit/camera command
network unit remote) connector (8-pin)
Connects to the RCP/CNU connector of a CCU-700A/700AP or the
RCP connector of a CNU-700 with a CCA-5-36XX cable.
2) AUX REMOTE (auxiliary remote) connector (8-pin)
103
PREVIEW
3 PREVIEW connector
Connects to an RCP-700/701.
3) PREVIEW connector (6-pin)
Supplies preview signals. The RCP-731 receives the power from the
external source, such as a video switcher, to illuminate the PREVIEW
button through this connector.
Adjusting the LCD Display
The RCP-730/731 is provided with LCD-display adjustment mode,
which permits you to adjust the brightness and contrast of the LCD
display of the paint control block.
1) To enter the LCD-display adjustment mode
While holding down the LOCK and PARA buttons, press the
WHITE button of the paint item select buttons. The LCD
display shows the following:
< D i s p l a y >
B r i g h t C o n t
2) To adjust the LCD display
Turn the paint controls (rotary encoders). You can adjust the
brightness with the control on the left and the contrast with
the control on the right.
3) To exit the LCD-display adjustment mode
Press the LOCK and PARA buttons simultaneously.
Note The values set in the LCD-display adjustment mode are stored in
memory when the modes are canceled. Be sure to exit this mode before
turning off the power.
r a s t