Space-Ray LTU Series Installation And Operation Instructions Manual page 30

The purpose of this type mounting is to allow the heater to be mounted in the plane of the roof (particularly in
modern "Butler" type buildings frequently used today). This will typically put the heater out of the way while still
providing the warmth and comfort. The heater can be inclined upwards from the control box to the draft inducer
at a distance of 2 inches up for every linear foot of the heater length. The total rise for each draft inducer is
tabulated in the table below:
TOTAL DRAFT INDUCER HEIGHT ABOVE HORIZONTAL FOR 2"/12" PITCH INSTALLATIONS TOTAL DRAFT INDUCER HEIGHT ABOVE HORIZONTAL FOR 2"/12" PITCH INSTALLATIONS
TOTAL DRAFT INDUCER HEIGHT ABOVE HORIZONTAL FOR 2"/12" PITCH INSTALLATIONS TOTAL DRAFT INDUCER HEIGHT ABOVE HORIZONTAL FOR 2"/12" PITCH INSTALLATIONS
MODEL MODEL MODEL MODEL
LTS 40-75
LTS 80-120
LTS 125-130
LTS 140-175
MODEL MODEL
MODEL MODEL
LTS 180-250
The heater is subject to all other requirements presented in these Installations Instructions, particularly the
Clearances to Combustibles. If you plan to use this type of installation, order the Space Ray Inclined Mounting
Kit, Part #43238000 Kit, Part #43238000.
Kit, Part #43238000 Kit, Part #43238000
Form #43155010
Sept 2011
15 Ft. 15 Ft. 15 Ft. 15 Ft. 20 Ft. 20 Ft. 20 Ft. 20 Ft. 25 Ft. 25 Ft. 25 Ft. 25 Ft.
30" 40" 50"
50 Ft. 50 Ft. 55 Ft. 55 Ft. 60 Ft. 60 Ft.
50 Ft. 50 Ft. 55 Ft. 55 Ft. 60 Ft. 60 Ft.
100" 110" 120"
Tube Length Tube Length Tube Length Tube Length
30 Ft. 30 Ft. 30 Ft. 30 Ft. 35 Ft. 35 Ft. 35 Ft. 35 Ft. 40 Ft. 40 Ft. 40 Ft. 40 Ft.
60"
60" 70"
60" 70"
Tube Length Tube Length
Tube Length Tube Length
65 Ft. 65 Ft. 70 Ft. 70 Ft. 75 Ft. 75 Ft.
65 Ft. 65 Ft. 70 Ft. 70 Ft. 75 Ft. 75 Ft.
130" 140"
-29-
45 Ft. 45 Ft. 45 Ft. 45 Ft. 50 Ft. 50 Ft. 50 Ft. 50 Ft.
80" 90" 100"
80" 90" 100"
80 Ft. 80 Ft.
80 Ft. 80 Ft.
150" 160"
Space Ray Inclined Mounting Space Ray Inclined Mounting Space Ray Inclined Mounting