Space-Ray LTU Series Installation And Operation Instructions Manual page 26

6. Assemble reflectors onto the body section. Reflectors should overlap 1" to 2" and must be secured by sliding
speed clips on the reflector edges. One speed clip is required for each side of the reflector.
7. Fasten the first reflector to the tube support/hanger bracket with (2) #10 sheet metal screws according to
Detail "A". Mount the sliding reflector clamps (#42769010) per Reflector Clamp Installation (Detail "B") on
all tube support/hanger brackets. Make sure the reflector can slide under the clamp during heater operation.
Form #43155010
Sept 2011
The reflector The reflector clamps MUST be installed per reflector The reflector The reflector clamps MUST be installed per reflector clamps MUST be installed per reflector clamps MUST be installed per reflector
clamp installation detail which allows the reflector to clamp installation detail which allows the reflector to
clamp installation detail which allows the reflector to clamp installation detail which allows the reflector to
slide under the clamp during heater operation. slide under the clamp during heater operation.
slide under the clamp during heater operation. slide under the clamp during heater operation.
DETAIL “A”
-25-
DETAIL “B”
Reflector Clamp Installation