Space-Ray LTU Series Installation And Operation Instructions Manual page 14

3. Assembly the reflectors onto the body section. Leave 3" space between the tube flange and the first
reflector for later mounting of control box and draft inducer.
4. Place the flanges of the control end reflector flush with the end of the first reflector. Secure by sliding speed
clips onto reflector edges. Evenly space 6 speed clips on sides and top of reflectors to provide a snug fit.
Place foot end reflector on the opposite end of the reflector and secure as above.
5. Attach the control box to the right-hand control tube flange and secure with 1/4-20 locknuts. The control box
must be mounted with the perforated fresh air plate on top, facing the ceiling.
6. Attach the draft inducer assembly to the left-hand draft inducer tube flange and secure with 1/4-20 locknuts.
A flue restrictor plate is attached to the draft inducer weld studs. Make sure this remains in place while the
draft inducer is being attached to the heater body.
Form #43155010
Sept 2011 -13-