Lts 180-250 Series Heater Assembly Overview; Lts Series Heater Assembly - Space-Ray LTU Series Installation And Operation Instructions Manual

11.3)

LTS 180-250 SERIES HEATER ASSEMBLY OVERVIEW

11.4)

LTS SERIES HEATER ASSEMBLY

During field assembly of the LTS series heater body sections, the recommended procedure is as follows:
1. Before hanging heater sections, first determine the actual layout of the system (see Sections 11.0) & 11.1)
for details). Consideration must also be taken for flue pipe, fresh air ducting, gas piping, clearances to
combustibles, etc. before hanging heater.
2. Put the suspension in place using proper suspension method (see Section 5.0).
3. Hang each tube section individually. Observe the following requirements.
a) DO NOT DO NOT attach the heater tube sections together on the ground and attempt to hang the entire system.
DO NOT DO NOT
The weight of the individual heater body sections can cause misalignment and damage to the heater The weight of the individual heater body sections can cause misalignment and damage to t
The weight of the individual heater body sections can cause misalignment and damage to t The weight of the individual heater body sections can cause misalignment and damage to t
b) DO NOT DO NOT relocate the tube support/hanger brackets, especially at the control end of the heater. relocate the tube support/hanger brackets, especially at the control end of the heater.
DO NOT DO NOT relocate the tube support/hanger brackets, especially at the control end of the heater. relocate the tube support/hanger brackets, especially at the control end of the heater.
c) For LTS40-200 Models, the first tube section MUST
mount control box.
d) For LTS225-250 Models, the first tube section MUST
e) For all LTS models, the last tube section MUST
which is to mount draft inducer.
f) Failure to attach the control box to the flange end as indicated above will void the manufacturer's Failure to attach the control box to the flange end Failure to attach the control box to the flange end Failure to attach the control box to the flange end
warranty. warranty. warranty. warranty.
g) Any S hook used in suspension should be crimped close.
Models: Models: LTS Models: Models: LTS LTS 180 LTS 180- - - - 2 2 2 2 0 0 0 0 0 0 0 0 180 180
Models: LTS 225 Models: LTS 225 Models: LTS 225 Models: LTS 225- - - - 250 250 250 250
MUST be a 10 ft. tube with one 24-hole flange which is to MUST MUST
MUST MUST be a 10 ft. tube with two 6-hole flanges. MUST
MUST MUST be an either 10 ft. or 5 ft. tube with one 24-hole flange MUST
as indicated above will void the manufacturer's as indicated above will void the manufacturer's as indicated above will void the manufacturer's
-22-
he heater. . . .
he heater he heater
Form #43155010
Sept 2011