Book-Type Originals; Using The Radf (Reversing Automatic Document Feeder) - Toshiba e-STUDIO287CS User Manual

HOW TO MAKE COPIES
1
Raise the RADF.
Note
• Raise it 60 degrees or more so that the size of the
original can be detected correctly.
2
Place the original with its face down on the
original glass and align it with the left rear
corner of the glass.
1
2
When you copy highly transparent originals
When you copy highly transparent originals such as OHP
films or tracing paper, place a blank sheet, which is the
same size as the original or larger, over the original.
3
4
3
Lower the RADF carefully.

Book-type originals

You can place book-type originals on the original glass.
5
Do not place any heavy objects (8 kg(18lb.) or over) on the
original glass and do not press on it with force.
Breaking the glass could injure you.
6
1
Raise the RADF.
2
Open the desired page of the original and
place it with its face down. Align it with the
left rear corner of the original glass.
When you make 2-sided copies from book-type originals
in modes such as book-type original to 2-sided copying or
dual page copying, align the center of the original on the
yellow indicator line of the original glass.
3
Lower the RADF carefully.
Note
• Do not lower the RADF forcibly when the original is
very thick. There will be no problem in copying even if it
is not fully lowered.
• Do not look directly at the original glass because
intensive light may escape during copying.
• If the original size is not detected correctly, press
[ZOOM] and select the desired original size.
 P.45 "Specifying both the original size and the copy
paper size separately"
Using the RADF (Reversing Automatic
Document Feeder)
• When scanning the duplex original with the RADF, do
not put your hand on the RADF. Paper may damage the
hand.
• When scanning the duplex original with the RADF, do
not put an object on the RADF. This could cause a paper
misfeed.
- 26 -