Compaq RAID Array 4100 User Manual page 63

6. Carefully pull the daughterboard away from the controller board
unplugging the signal connectors.
1
Figure 4-19. Removing the daughterboard
7. Align the connectors of the new daughterboard with the controller
board; plug the daughterboard onto the RA4000 Controller
the connectors are fully mated by squeezing the boards together at the
connector side.
8. Align the plastic standoff on the daughterboard with the slot in the
controller board. Push it through and rotate the latch 90 degrees to lock
the board in place
2
Figure 4-20. Installing the daughterboard
2
.

1
Troubleshooting 4-15
,

. Be sure