Options Rompaq; Running The Procedure - Compaq RAID Array 4100 User Manual

Use the Options ROMPaq utility to update the firmware on the RA4000
Controller and hard drives.
NOTE: The RA4000 Controller firmware included in a new RA4100 may not be the latest
version available. Check the Compaq website at www.compaq.com to determine whether
you should update the firmware version.

Running the Procedure

To run Options ROMPaq:
1. Put the server in STANDBY mode.
2. Place the Options ROMPaq diskette 1 in the server floppy drive.
3. Boot the server by turning on the power.
4. Press Enter at the Welcome screen.
5. At the Select a Device screen, select All RA4000 Controllers from the
list of programmable devices. Press Enter.
6. If the ROM firmware in the RA4000 Controller is the same or newer
than that on the Options ROMPaq diskette, you will get the message:
The ROM image files found for the device selected are not newer than the current ROM
image
Chapter

Options ROMPaq

6