This chapter describes the operational features of the Compaq StorageWorks
RAID Array 4100.
Applying Power
Before applying power to the RA4100, all components of the storage system
must be installed and connected to the Storage Hub. Hard drives should be
installed in the RA4100 so that they can be identified and configured at power
up.
The StorageWorks RAID Array 4100 components must be powered up in the
following order:
1. Storage Hub(s)—Power is applied when the AC power cord is
plugged in.
2. RA4100(s)—Powered on with the power switch located in the upper
right corner of the front panel.
3. Server(s).
LEDs
The RA4100 is equipped with a series of LEDs located on strategic
components. With the exception of the LEDs located on the front panel, these
LEDs relate only to individual components.
3
Chapter
Operation