Troubleshooting - Freemotion Incline Trainer User Manual

TROUBLESHOOTING

Most incline trainer problems can be solved by following the steps below. Find the symptom that applies,
and follow the steps listed. If further assistance is needed, please see the back cover of this manual.
1. SYMPTOM: THE POWER DOES NOT TURN ON
a. Make sure that the power cord is plugged into a properly grounded outlet. (See page 11.)
b. Make sure that the key is inserted into the console.
c. Check the reset/off circuit breaker located on the incline trainer near the
power cord. Make sure that the reset/off circuit breaker is switched to the
"reset" position.
2. SYMPTOM: THE POWER TURNS OFF DURING USE
a. Check the reset/off circuit breaker located on the incline trainer near the power cord. (See drawing c above.)
Make sure that the reset/off circuit breaker is switched to the "reset" position.
b. Make sure that the power cord is plugged in.
c. Remove the key from the console. Reinsert the key into the console.
d. Check the walking belt and the walking platform for excessive wear. Replace the walking belt or the walking
platform if necessary.
e. If the power still turns off during use, please see the back cover of this manual.
3. SYMPTOM: THE WALKING BELT SLOWS WHEN WALKED ON
a. If the walking belt is overtightened, performance may
decrease and the walking belt may be damaged. If
the walking belt is properly tightened, you should be
able to lift each side of the walking belt 1 to 2 in. (2.5
to 5 cm) off the walking platform. If adjustments
need to be made, first remove the key and unplug
the power cord. Using a 7/32" hex key, turn both
idler roller adjustment bolts counterclockwise 1/4 of a
turn. Then, plug in the power cord, insert the key,
and use the incline trainer for a few minutes. Be care-
ful to keep the walking belt centered. Repeat until the
walking belt is properly tightened. Note: To tighten
the walking belt, see step 4. c. on page 28.
b. If the walking belt still slows when walked on, please see the back cover of this manual.
a
27
c
Reset
Position
2.5 to 5 cm
Idler Roller Adjustment Bolts