Removing The Front Fender; Installing The Front Fender; Removing The Shock Absorber - HUSABERG FE 450 EU Owner's Manual

12 SERVICE WORK ON THE CHASSIS
12.16

Removing the front fender

12.17

Installing the front fender

12.18

Removing the shock absorber

Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the headlight mask with the headlight. (
Main work
–
Remove screws
–
Take the brake line and wiring harness out of the brake line guide.
–
Disconnect the connector of the front turn signals.
101851-10
–
Remove screws
L00210-11
Main work
–
Position the front fender. Mount and tighten screws
Guideline
Remaining screws, chassis
L00210-10
–
Position the brake line and wiring harness in the brake line guide.
–
Connect the connector of the front turn signals.
–
Mount and tighten screws
Guideline
Remaining screws, chassis
101851-11
Finishing work
–
Install the headlight mask with the headlight. (
–
Check the headlight setting. (
x
Preparatory work
–
Raise the motorcycle with a lift stand. (
.
1
. Take off the front fender.
2
.
2
p. 82)
p. 41)
p. 80)
.
1
M6 10 Nm (7.4 lbf ft)
M6 10 Nm (7.4 lbf ft)
p. 80)
48