Lubricating The Steering Head Bearing; Removing The Front Fender; Installing The Front Fender - HUSABERG FE 250 USA 2014 Owner's Manual

12 SERVICE WORK ON THE CHASSIS
12.14

Lubricating the steering head bearing

12.15

Removing the front fender

12.16

Installing the front fender

Finishing work
–
Check the steering head bearing play.
–
Remove the motorcycle from the lift stand. (
x
–
Remove the lower triple clamp.
–
Install the lower triple clamp.
800010-10
Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the headlight mask with the headlight. (
Main work
–
Remove screws
–
Take the brake line and wiring harness out of the brake line guide.
–
Disconnect the connector of the front turn signals.
101851-10
–
Remove screws
L00210-11
Main work
–
Position the front fender. Mount and tighten screws
Guideline
Remaining screws, chassis
L00210-10
–
Position the brake line and wiring harness in the brake line guide.
–
Connect the connector of the front turn signals.
–
Mount and tighten screws
Guideline
Remaining screws, chassis
101851-11
( p. 44)
x
( p. 45)
x
.
1
. Take off the front fender.
2
.
2
p. 41)
p. 79)
.
1
M6 10 Nm (7.4 lbf ft)
M6 10 Nm (7.4 lbf ft)
47