Changing The Hydraulic Clutch Fluid; Removing The Engine Guard; Installing The Engine Guard - HUSABERG FE 450 EU Owner's Manual

12 SERVICE WORK ON THE CHASSIS
12.47

Changing the hydraulic clutch fluid

Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
12.48

Removing the engine guard

12.49

Installing the engine guard

x
–
Move the clutch fluid reservoir mounted on the handlebar to a horizontal position.
–
Remove screws
–
Remove cover
B01538-10
–
Fill bleeding syringe
Bleed syringe (50329050000)
Brake fluid DOT 4 / DOT 5.1 (
–
On the slave cylinder of the clutch, remove bleeder screw
syringe
4
B01260-10
–
Inject the liquid into the system until it escapes from openings
cylinder without bubbles.
–
To prevent overflow, drain fluid occasionally from the master cylinder reservoir.
–
Remove the bleeding syringe. Mount and tighten screws bleeder screw.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container rim
–
Position the cover with the membrane. Mount and tighten the screws.
B01540-10
–
Turn quick release
guard.
B01261-10
–
Attach the engine guard on the frame at the rear and swing up at the front.
–
Turn quick release
L00216-10
.
1
with membrane .
2 3
with the appropriate hydraulic fluid.
4
p. 106)
.
counterclockwise until it disengages. Remove the engine
1
clockwise all the way.
1
and mount bleeding
5
of the master
6
4 mm (0.16 in)
62