Removing The Headlight Mask With The Headlight; Installing The Headlight Mask With The Headlight - HUSABERG FE 450 EU Owner's Manual

15 ELECTRICAL SYSTEM
15.6

Removing the headlight mask with the headlight

15.7

Installing the headlight mask with the headlight

–
Remove the defective fuse.
Guideline
Fuse 1 - 10 A - EFI control unit
Fuse 2 - 10 A - fuel pump
Fuse 3 - 10 A - high beam, low beam, parking light, tail light, license plate lamp
Fuse 4 - 10 A - horn, brake light, turn signal, radiator fan
Fuses res - 10 A - spare fuses
B01642-10
Info
A defective fuse can be identified by the burned-out fuse wire
Warning
Fire hazard The electrical system can be overloaded if the wrong fuses are
used.
–
–
Use spare fuses with the correct rating only.
Fuse (75011088010) (
Tip
Replace the spare fuse in the fuse box so that it is available if needed.
–
Check that the power consumer is functioning properly.
–
Close the fuse box cover.
Finishing work
–
Mount the seat. (
Preparatory work
–
Switch off all power consumers and switch off the engine.
Main work
–
Open rubber bands
–
Tilt the headlight mask forward and detach at catch
–
Disconnect connector
–
Take off the headlight mask with headlight.
101854-10
Main work
–
Plug in connector
–
Check that the lighting is functioning properly.
–
Attach headlight holder
101854-11
Use only fuses with the prescribed amperage. Never by-pass or repair
fuses.
p. 103)
p. 49)
on the fork legs.
1
.
3
.
1
at catch
2 3
.
2
and position the headlight mask.
80
.
A