HUSABERG FE 450 EU Owner's Manual page 93

18 SERVICE WORK ON THE ENGINE
–
Push the engine oil screen
–
Push the pin wrench through the opening into the drill hole of the opposite engine
case wall and push the oil screen as far as possible into the engine case.
B01273-10
–
Mount and tighten screw plug
Guideline
Screw plug, engine oil screen
–
Mount and tighten the oil drain plug
Guideline
Oil drain plug with magnet
C00069-10
–
Remove screws
B01274-10
–
Pull oil filter
Circlip pliers reverse (51012011000)
–
Completely drain the engine oil.
–
Thoroughly clean the parts and sealing area.
B01275-10
– Lay the motorcycle on its side and fill the oil filter housing to about ⅓ full with
engine oil.
–
Insert the oil filter into the oil filter housing.
–
Oil the O-ring of the oil filter cover and mount it with the oil filter cover
–
Mount and tighten the screws.
Guideline
Screw, oil filter cover
–
Stand the motorcycle upright.
B01276-10
–
Remove the oil filler plug
engine oil.
Engine oil
B01277-10
Info
Too little engine oil or poor-quality engine oil results in premature wear to
the engine.
with the O-rings onto a pin wrench.
4
with the O-ring.
3
with the magnet and a new seal ring.
1
. Remove the oil filter cover with the O-ring.
5
out of the oil filter housing.
6
with the O-ring from the clutch cover and fill up with
8
1.50 l (1.59 qt.)
M20x1.5 15 Nm
(11.1 lbf ft)
M12x1.5 20 Nm
(14.8 lbf ft)
M5 6 Nm (4.4 lbf ft)
Engine oil (SAE 10W/50) (
Alternative engine Engine oil
oil for harsh oper- (SAE 10W/60)
ating conditions (00062010035)
and increased per- ( p. 106)
formance
91
.
7
p. 106)