Riso Perfect (G) ComColor Series User Manual page 54

Other problems
The perfect binder does not operate at
all.
The setting buttons of the perfect binder
is not displayed on the printer's touch
panel.
It takes long time to start binding since
the binding job is sent.
The spine is undulated.
The booklet hardly opens.
● For the troubles related to the print condition or printer, see the printer manual.
● For the troubles related to original data, see the Application Guide of the Perfect binder software.
2-14
Status Reason and Action to Take
Make sure that the main power of the printer and Perfect binder has
been turned on.
Make sure that the power plug of the printer and Perfect binder has
been properly inserted into the electrical outlet.
Make sure that the power cords have been securely connected to
the printer and Perfect binder.
Make sure that the power breaker has not been tripped.
Turn off the power of the printer and Perfect binder and then turn on
again.
If the perfect binder does not recover, contact your dealer (or
authorized service representative).
Make sure that the main power of the Perfect binder has been
turned on.
If the temperature of the glue and glue tank is not suitable, the
heater warms up the glue until it reaches to the suitable
temperature and then the binding begins. Preheat the glue to the
suitable temperature, so that the binding begins sooner.
For the glue temperature of the glue unit, see "Glue Temperature"
(p. 1-4).
Check the cover sheet's texture. Use the short-grained paper for
the cover sheet, so that the cover's texture becomes long-grained
when bound up. For details on the cover sheet's texture, see
"Cover Sheet" (p. 19).
Perfect binder User's Guide 05