Riso Perfect (G) ComColor Series User Manual page 51

Message
Set the body in the body sheet
stacker of the perfect binder.
The optional device has not been
powered on. To use the optional
device, power on the optional
device and then the main unit.
Load paper in the cover
sheet inserter.
The maximum body size allowed
for perfect binder stacking has
exceeded. Check the settings
(The job has been deleted).
Pages might overlap.
To proceed, check the pages
after the binding is completed.
Cover width that cannot be handled by
the perfect binder has been detected.
Check the settings.
(The job has been deleted).
Paper width that cannot be handled by
the perfect binder has been detected.
Check the settings.
(The job has been deleted).
The perfect binder output tray
is full.
Remove the booklets.
Pressing the eject button will
eject the booklets
<I000-000> Information
This message is displayed when maintenance of the machine is required.
Message
The perfect binder glue sheet must
be replaced soon.
Call service to prepare
a new glue sheet.
Action to Take
There is no paper in the body sheet stacker of Perfect binder.
Load the body sheets in the body sheet stacker.
The power of the Perfect binder is "OFF". Turn the power "ON".
There is a sequence to turn on the power of the Perfect binder.
See "Turning the Power ON/OFF" (p. 23) for details on turning
the power on.
There is no cover sheet in the cover sheet inserter of Perfect
binder. Load the cover sheet in the cover sheet inserter.
Original data exceeds the maximum stacking capacity. Press
[Close]. Edit data and send it again.
For the binding capacity (thickness), see "Usable Paper" (p. 12).
Paper is jammed in the body sheet stacker. Remove the
jammed paper and press [Cancel] or [Continue]. If the printing is
continued, check if the booklet has misbound or not.
The booklet cannot be bound up with the current cover size
(width). Press [Close] and send original data with the available
cover size. For the correct combination of the cover and body
pages, see "Usable Paper" (p. 12).
The booklet cannot be bound up with the current body page size
(width). Press [Close] and send the original data with the
available body pager size. For the correct combination of the
cover and body pages, see "Usable Paper" (p. 12).
The booklets ejected to the Perfect binder's output tray exceeds
the maximum stacking capacity.
Remove the booklets and press the eject button.
Some booklets may be left inside the machine. Press
the eject button until no booklet is ejected.
Action to Take
The remaining amount of glue sheet is low. Check your stock
and place an order if required.
This message does not mean that the binding is imme-
diately disabled. Depending on the usage condition,
contact your dealer (or authorized service representa-
tive).
Troubleshooting
Perfect binder User's Guide 05
2
2-11