Riso Perfect (G) ComColor Series User Manual page 39

■ Setting on the Operation Panel
1 Press [Perfect binder; Cover] on
the [Admin. Settings] screen.
2 Press [ON] and set [Cover cutting
position] and [Cover gluing
position].
For [Cover cutting position], press [▲] to move the
position 0.1 mm (0.005") to the right so that the
cut-off area increases; press [▼] to move the
position 0.1 mm (0.005") to the left so that the cut-
off area decreases.
For [Cover gluing position], press [▲] to move the
position 0.1 mm (0.005") to the left; press [▼] to
move the position 0.1 mm (0.005") to the right
(closer to the cut-off area).
Sometimes the maximum settings (± 30 mm (1
3/16")) for [Cover cutting position] and [Cover
gluing position] may be disabled. Depending
on the paper, the maximum value is set auto-
matically.
Press [OK].
3
■ Setting on the RISO Console
While processing the binding job, change
[Perfect binder; Cover] from the RISO Console
so that the finishing of the processing job is
changed. Before changing the setting, confirm
the job setting to the user who has sent the
binding job or wait until the binding job is fin-
ished.
Click [Admin.] in the monitoring
1
screen.
Click [Perfect binder; Cover].
2
3 Select [Cover cutting] and adjust
the cover cutting position and
cover gluing position.
4 Click [OK].
Perfect binder User's Guide 05
Administrator Settings
1
1-9