Riso Perfect (G) ComColor Series User Manual page 26

■ Confirming on the Operation Panel
Confirm that the power of the
1
printer and Perfect binder is
turned ON.
2 Press [Status] on the mode screen.
3 Confirm the status of the printer
and the Perfect binder.
When the Perfect binder becomes the stand-by
mode, "Ready to start binding up." is displayed.
You can bind up a booklet with the glue and glue
tank in adequate temperature.
When the power of the Perfect binder is OFF,
the power does not turn ON automatically by
sending the binding job. Turn the power ON
manually before use. (p. 23 "Turning the
Power ON")
The Status of the Perfect binder
(Warming up Mode/Stand-by Mode/
Cooling down Mode/Sleep Mode)
When the power of the Perfect binder is turned ON,
the Perfect binder goes to the sleep mode or
warming up mode.
24
• Warming up mode
The Perfect binder warms up the glue and glue
tank. When the both of them reaches to the
suitable temperature, it goes to the stand-by
mode and the Perfect binder is ready to bind up.
• Stand-by mode
The machine is ready for binding. When the
binding job printing does not start in time set by
the administrator, it goes to the cooling down
mode; the glue heater runs at the lower
temperature to prevent the deterioration of the
glue.
• Sleep mode
The glue and glue tank are not warmed up.
In other than the stand-by mode, the Perfect
binder starts warming up the glue and glue tank
when the binding job is sent. At the time when
the both of them reaches to the suitable
temperature, the binding begins.
● On the operation panel and RISO Console,
the Perfect binder's status is displayed as
shown below.
Display
Warming up
Ready to start
binding up.
Cooling down
Sleeping
● You can change the transit time to the
cooling down mode or the sleep mode in
the "Admin. Settings".
(p. 1-7 "Perfect binder Settings")
Perfect binder User's Guide 05
Machine Binding
Status Operation
Warming N/A
up mode
Stand-by
mode
Cooling N/A
down mode
Sleep N/A
mode