Master Section - ALLEN & HEATH XONE:DB4 User Manual

Allen & Heath

MASTER SECTION

USB A TYPE SOCKET
1
Allows insertion of a USB memory stick for the purposes of
1
loading and saving settings and for Firmware updates. See Page
26 for information on Firmware updating.
2
We strongly recommend that you use a dedicated
USB flash drive for loading and saving settings.
3
MIX / MONITOR METERS
2
4
The main meters follow the selected monitor source. The
meter reads '0' for an XLR output of +4dBu.
should be operated with these meters averaging around '0'
with loudest peaks no higher than '+6'.
In SPLIT CUE mode, whilst a channel cue button is pressed,
5
the left meter will display the CUE level and the right meter
will display the PROGRAM (PRG) level. For more about CUE
modes please see "Headphone Setup" on Page 24.
6
MIX MASTER LEVEL CONTROL
3
A rotary master control adjusts the level of the main mix XLR
outputs feeding the house sound system. This does not affect
the monitor output or the meter reading.
BOOTH MASTER LEVEL CONTROL
4
Adjusts the level of the signal to the stereo monitor RCA
output. This does not affect the headphones. The monitor
output could be used for a booth monitor, recording or an
additional zone feed.
CUE / ADD MIX CONTROL
5
Pans between Cue signal and the Main Mix output. Turned
fully anti-clockwise, only the active Cue signal is heard through
the headphones when a Cue is selected. Gradually turning
clockwise introduces the Main Mix output to the Cue signal
until, fully clockwise, only the Mix is heard. This does not
affect the meters. Split Mode pans Left (Cue) to Right (Mix),
see Page 24.
MONTOR LEVEL CONTROL
6
Adjusts the level of the headphone signal. The head-
phone level can be further trimmed up or down in level
in the Setup Menu: see Page 24.
Warning ! To avoid damage to your hearing do not
!
operate the headphones or sound system at excessively
high volume.
sound can cause frequency selective or wide range
hearing loss.
Continued exposure to high volume
13
The mixer
XONE:DB4 User Guide