Music Channels - ALLEN & HEATH XONE:DB4 User Manual

1
6
7
Allen & Heath
MUSIC CHANNEL
MATRIX INPUT SELECTOR
1
Please refer to Page 15 for further information
on how to use this feature.
2
INPUT TRIM
3
2
Amplifies or attenuates the input signal by up to
±10 dB.
INPUT PEAK LED
3
4
Illuminates if input signal is within 3dB of
clipping. If this happens lower the Trim level.
EQ SECTION
4
Configured as either Three band EQ or High-
Pass/Low-Pass
position. Please refer to Page 16 for further
details on this feature.
5
LOOP RECORDER
5
Records and automatically loops input source
when activated. Display shows loop length, and
beat detection activity. Please refer to Page17
for further details on this feature.
8
FX TYPE SELECT BUTTONS
6
Selects one of the five basic effects types. Each
selection overrides the previous one. Buttons
9
will illuminate green to show effect selected or
orange when channel is in focus. Please refer to
Page 18 for further details on this feature.
FX SELECT
7
Press to move focus to channel. If the channel
has focus then press to open FX library Please
refer to Page 18 for further details on this
feature.
FX EXPRESSION CONTROL
8
Changes one parameter of selected FX, e.g.
regeneration if delay selected. Please refer to
Page 18 for further details on this feature.
FX WET/DRY CONTROL
9
The WET/DRY control sets the level of the
effect from no effect (DRY) when fully
anticlockwise to maximum effect (WET) when
fully clockwise.
further details on this feature.
10
filter depending
Please refer to Page 18 for
XONE:DB4 User Guide
on switch