ALLEN & HEATH XONE:DB4 User Manual page 9

Allen & Heath
MIC / LINE CHANNEL
CHANNEL CUE SWITCH
7
Press the Cue switch to listen to the channel pre-fade signal
in the headphones and view its level on the main meters.
The backlit switch lights red when selected. Press the
switch again to deselect cue.
CHANNEL LEVEL CONTROL
8
Sets the level of the channel signal in the main mix.
CHANNEL ON SWITCH
9
Turns the channel on, allowing the channel signal to
be routed to the main mix. This feature is very
useful if a microphone is being used as it can be
switched in and out of the mix.
MIX / CH1 SWITCH
10
Selects where the channel output will be routed:
MIX - Routes the signal directly to the mix
CH1 - Routes the signal to the input of Channel 1
If the switch is set to CH1, the 'MIC' LED will illuminate in
Channel 1, overriding the matrix input to that channel.
7 This will enable loops and effects to be applied to the
microphone input.
8
9
10
9 XONE:DB4 User Guide