ALLEN & HEATH XONE:DB4 User Manual page 11

10
11
13
14
Allen & Heath
MUSIC CHANNEL
FILTER ASSIGN SWITCH
10
Set the 3-position switch to its mid position to
route the signal direct to the mix, or to its left
or right positions to route the signal to Filter-1
or Filter-2 respectively. See page 12 for more
information on the filter system.
X-FADE ASSIGN SWITCH
11
Set the 3-position switch to its mid position to
route the signal direct to the mix, or to its left
or right positions to route the signal to
Crossfade-X or Crossfade-Y respectively.
CHANNEL CUE SWITCH
12
Press the cue switch to listen to the channel pre
-fade signal in the headphones and see its level
on the main meters. The button will illuminate
when selected.
Press the switch to deselect cue. The switches
are interlocked; pressing another one turns off
the previous selection.
Multiple cueing may be achieved in one of two
ways:
1.
2.
1 CHANNEL METER
13
Displays the channel signal level. It is post-EQ
post-FX, and pre-fader.
The channel level control should be set so that
the channel meter averages around '0', with
loudest peaks no higher than '+6'. Turn down
the Trim control if the PK! indicator lights.
CHANNEL FADER
14
A high quality, smooth travel, dual-rail fader
adjusts the channel signal level from fully off to
fully on.
11
Pressing two or more cues simultaneously.
Holding down an active cue allows
momentary activation of any other cue
when pressed.
XONE:DB4 User Guide