Panasonic KX-TA308 Installation Manual page 73

3 Features
*9: If the destination extension belongs to a hunting group and all extensions in the group are busy,
the system will check the DISA Busy Mode. If the destination is a DISA ring group, the DISA
Busy Mode will not work for the call. The system regards the call as unanswered.
*10: The DISA Busy Mode is selected in program [506]. There are 3 modes as follows.
• Disconnect –
• Call Waiting – The destination extension hears a call waiting tone if they have enabled
• DISA2 –
*11: The DISA Ring Timer Before Intercept starts. The destination telephone(s) will ring for the
time programmed in [508].
*12: In this case, the system disregards the security type and does not accept a line access code. If
nothing is recorded in OGM2 or OGM2 is used for another caller, the caller will hear a busy
tone and the call is disconnected.
*13: The OGM is sent to the caller according to programs [414]–[416] and [502] when the
assigned time in program [519] expires. If an OGM is not recorded, the DISA Wait Timer
After OGM programmed in [505] starts immediately.
When the system detects a FAX (CNG) tone while the OGM is being sent, the call is sent to
the FAX extension assigned in program [503]. When the system detects a cyclic tone or CPC
signal while the OGM is being sent, the call is disconnected.
*14: The DISA Wait Timer After OGM starts. The system waits for a number from the caller
during the time assigned in program [505]. When the system detects a FAX (CNG) tone
during the programmed time, the call is sent to the FAX extension. When the system detects a
cyclic tone or CPC signal during the programmed time, the call is disconnected.
*15: After the DISA Wait Timer After OGM or the Intercept Timer for Internal DISA expires, the
system regards that nothing was dialed.
*16: The system treats the call according to program [510] as follows.
• Disconnect –
• Intercept –
*17: The DISA Ring Timer After Intercept starts. The destination telephone(s) will ring for the
time programmed in [509]. If the call is not answered during the programmed time, the call
will be disconnected.
*18: The FAX extension assigned in program [503] receives the call. When the extension is busy,
the system sends a busy tone to the sending FAX. If the call is not answered after 40 seconds,
the call will be disconnected.
Program [514] sets how many times the FAX (CNG) tone must be detected before the system
recognizes the incoming signal as facsimile data.
The caller hears a busy tone and a call is disconnected.
Call Waiting.
If "MODE2" is assigned in program [502] and a message is recorded in
OGM2, the caller will hear the message and the system waits for the new
destination.
He call is disconnected.
The call is sent to the extensions programmed in [408]-[410]. If all
extensions are assigned to "Disable", the call will be disconnected.
D
3-23
Features