4.2
System Programming
[421] CPC Detection for Outgoing Calls
Enables or disables the CPC signal detection during an outgoing outside call. If disabled,
the CPC signal detection is only activated during an incoming outside call or after call hold.
4
* Outside (CO) line number: 1 through 6 /
Default
• Feature Reference
Section 3, Features
Calling Party Control (CPC) Signal Detection
[422] Disconnect Time
Determines the amount of time to send the disconnect signal from the system to the Central
Office or host PBX. The time you select must be longer than the requirements of your
Central Office or host PBX.
4
* Outside (CO) line number: 1 through 6 /
Default
• Feature Reference
Section 3, Features
Flash
2
1
NEXT
All outside (CO) lines – Disable
2
2
NEXT
All outside (CO) lines – 1.5 seconds
or
NEXT
outside line no.*
(1···6/ )
(Enable/
SELECT
(All outside lines)
or
NEXT
outside line no.*
SELECT
(1···6/ )
(0.5/ 1.5/
4.0 sec)
SELECT
(All outside lines)
[421]-[422]
PREV
To continue
STORE
SELECT
Disable)
To continue
PREV
To continue
STORE
To continue
System Programming
END
END
4-53