Stylus Pro 4000 Field Repair Guide
Multi Sensor Adjustment for Auto Nozzle Check
1. Load 17" Enhanced Matte roll paper.
2. From the
Adjustment Wizard
Nozzle Check.
Multi Sensor Adjustment for Auto Nozzle Check
for the Pro 4000, select the
Printer Component,
Software Item,
Mulit Sensor Adjustment for Auto
1. Click on the
Run
button.
2. The Printer will print out these patterns.
3. The Printer will read the alignment patterns
automatically (using the Multi Sensor), and
write the appropriate values to the board.
4. Click on the
Print Check Pattern
5. Click on the
Run
button.
6. The Printer will Print a check pattern, followed
by a nozzle check pattern.
7. Click the
Finish
button.
LCD Display,
Printer Button
4/28/05
button.
Page 153.