Riser Card - Toshiba Equium 5160D Series Preliminary Maintenance Manual

Removing the Rear Panel
To remove the computer's rear panel, perform the following procedure and see Figure
1. Turn off power to the computer, then disconnect the power cord and all external cables
connected to the computer.
2. Release the three tabs on the back panel from their latches on the chassis.
3. Carefully pull the back panel away from the chassis, making sure that the latches on the
bottom of the panel are free from the corresponding tabs on the bottom of the chassis.
Figure 4-12 Removing and Replacing the Rear Panel
Replacing the Rear Panel
To replace the computer's rear panel, perform the following procedure and see Figure
1. Angle the top edge of the back panel so that the three tabs at the top of the panel are
aligned directly below the corresponding latches on the chassis.
2. Gently push the bottom of the panel in (toward the computer) until the three latches on
the bottom of the panel are secured by the corresponding tabs on the bottom of the
chassis.
3. Connect the power cord and all external cables to the computer and turn on the power.

Riser Card

This section covers the removal and replacement of the computer's riser card.
Removing the Riser Card
To remove the computer's riser card, perform the following procedure and see Figure
4-13.
1. Turn off power to the computer, then disconnect the power cord and all external cables
connected to the computer.
2. Remove the computer's cover. (Refer to section 4.2.1.)
3. Remove any expansion card from the riser card. (Refer to section 4.1.4.)
Equium™ Series Maintenance Manual --------------------------------------------------------- 4-15
4-12.
4-12.