Toshiba Equium 5160D Series Preliminary Maintenance Manual page 66

3. Disconnect the power cable, the data cable, and the audio cable from the CD-ROM
drive.
Figure 4-17 Disconnecting and Connecting CD-ROM Drive Cables
NOTE: Because the CD-ROM bracket and the FDD/HDD mounting bracket are
side-by-side in the chassis, you must remove this mounting bracket before you
can remove the CD-ROM drive.
1. Remove the FDD/HDD mounting bracket. (Refer to section 4.7.1.)
2. Remove the four (two on each side) screws that secure the CD-ROM drive to its
bracket.
3. Carefully slide the CD-ROM drive out of its bracket.
Figure 4-18 Removing and Replacing the CD-ROM Drive
Equium™ Series Maintenance Manual --------------------------------------------------------- 4-22