Hard Disk Drive (Hdd) - Toshiba Equium 5160D Series Preliminary Maintenance Manual

Replacing the Power Supply
To replace the power supply, perform the following procedure and see Figure 4-14.
1. Set the power supply in place with the AC power cord connector at the bottom and the
screw holes properly aligned with the corresponding holes on the chassis. Secure the
power supply to the chassis using four screws.
2. Connect power cable P1 to the connector at J9H1 on the system board.
3. Connect power cable P2 to the connector at J9J1 on the system board.
4. Connect power cable P12 to the connector at J9K2 (J9F1 6200D) on the system board.
5. Connect power cable P8 to the FDD.
6. Connect power cable P5 to the HDD.
7. Connect power cable P7 to the CD-ROM drive.
8. Replace the computer's rear panel. (Refer to section 4.2.4.)
9. Replace the computer's cover. (Refer to section 4.2.2.)
10. Connect the power cord and all external cables to the computer and turn on the power.

Hard Disk Drive (HDD)

This section covers the removal and replacement of the computer's hard disk drive.
Removing the HDD
To remove the computer's HDD, perform the following procedure and see Figures 4-15 and
4-16.
1. Turn off power to the computer, then disconnect the power cord and all external cables
connected to the computer.
2. Remove the computer's cover. (Refer to section 4.2.1.)
3. Disconnect the power cable and the data cable from the HDD.
Figure 4-15 Disconnecting and Connecting HDD Cables
Equium™ Series Maintenance Manual --------------------------------------------------------- 4-19