NOTE: Because the HDD and the FDD are attached by a mounting bracket,
you must remove the cables from the FDD in order to remove the bracket from
the chassis.
1. Remove the power and data cable from the FDD. (Refer to section 4.7.1.)
NOTE: Because the HDD and the FDD are attached by a mounting bracket,
you must remove this bracket in order to remove the HDD.
1. Remove the FDD/HDD mounting bracket. (Refer to section 4.7.1.)
2. Remove the four (two on each side) M3 screws that secure the HDD to the mounting
bracket.
Equium™ Series Maintenance Manual --------------------------------------------------------- 4-20