System Board (6200D) - Toshiba Equium 5160D Series Preliminary Maintenance Manual

1. Connect switch and LED cables and the fan cable:
Connect the FAN cable to the pins labeled FAN (red cable to pin 2 and black
cable to pin 3) on the system board.
Connect the RESET switch cable to the pins labeled RST (black cable to pin 4
and red cable to pin 5) on the system board.
Connect the POWER LED cable to the pins labeled PWRLED (green cable to pin
7 and black cable to pin 9) on the system board.
Connect the H.D.D. LED cable to the pins labeled HD LED (blue cable to pin 11
and black cable to pin 12) on the system board.
Connect the POWER SW cable to the pins labeled PS-ON (yellow cable to pin 15
and black cable to pin 16) on the system board.
Connect the SLEEP SW cable to the pins labeled SLP (white cable to pin 17 and
black cable to pin 18) on the system board.
Figure 4-23 5160D/5200D Switch and LED Cable Connections
2. Replace the computer's cover. (Refer to section 4.2.2.)
3. Connect the power cord and all external cables to the computer and turn on the power.

System Board (6200D)

This section covers the removal and replacement of the 6200D system board.
Removing the System Board (6200D)
To remove the 6200D system board, perform the following procedure and see Figure
Equium™ Series Maintenance Manual --------------------------------------------------------- 4-29
4-24.