Brake-Shift Interlock; Park Brake - Foot Pedal; Tow/Haul Transmission Mode; Map Light Switch - Winnebago 2011 sunova Operator's Manual

BRAKE-SHIFT INTERLOCK

®
Ford Chassis
The Brake-Shift Interlock is a safety feature
that prevents the shift lever from being moved
from the Park position unless the ignition is ON
and the service brake pedal is pressed.
NOTE: If the brake light fuse is blown, the
interlock feature will not work properly
and an alternate method must be used.
See the chassis manual provided in your
InfoCase for detailed instructions on
what to do in this situation.
PARK BRAKE – FOOT PEDAL
®
Ford Chassis
The park brake foot pedal and release lever are
located beneath the left side of the dash.
Step the pedal down fully to apply and pull the
brake release knob to disengage.
TOW/HAUL TRANSMISSION
MODE
®
Ford Chassis only
This mode locks out Overdrive and helps
reduce gear "hunting" by the automatic
transmission while towing. It also improves
power delivery and uses engine braking to help
control vehicle speed when descending hills.
This mode may also be useful when the coach
is fully loaded or when driving into a strong
headwind.
• Press the button at the end of the shift
lever to engage Tow/Haul Mode
when pulling a trailer or tow vehicle
DRIVING YOUR MOTOR HOME
Further Information
See the chassis manual in your InfoCase for
further operating instructions and cautions.

MAP LIGHT SWITCH

Turn the driver side map light on using the
Panel Dim thumbwheel. Roll it up to maximum
position until you feel it click into the map light
"On" position.
Further Information
See the chassis manual in your InfoCase for
further information on this switch.

HAZARD WARNING FLASHERS

The hazard warning flashers provide
additional safety when the vehicle must be
stopped on the side of the roadway and presents a
possible hazard to other motorists. When the
flashers are on, it serves as a warning to other
drivers.
Further Information
See your chassis manual for instructions on
activating, operating, and canceling hazard
warning flashers.

BATTERY BOOST SWITCH

The Battery Boost switch can be used to draw
emergency starting power from the house
batteries to start the engine if the chassis battery
is discharged.
Press and Hold the Battery Boost switch in the
ON position while turning ignition key for
emergency starting power.
SECTION 3 –
Roll panel
light dimmer
wheel
upward fully
to turn driver
side map
light on.
3-7