Chassis Service And Maintenance - Winnebago 2011 sunova Operator's Manual

Table of Contents

Advertisement

SECTION 11 –
MAINTENANCE AND STORAGE
system (if equipped). See appropriate filter
installation instructions in Section 7 -
Plumbing.
NOTE: Always purge a new filter with clean
running water before using. See filter
manufacturer's directions included with
the filter cartridge.
10. Check the toilet for proper operation.
11. Add water to the holding tank using the toilet
flush pedal (or the "Normal Flush" switch if
your coach is equipped with an electric flush
toilet) and galley sink faucet. Check to be sure
dump valves seal tightly.
12. Check around all appliances for obstructions
and ensure that all vent openings are clear.
13. Start refrigerator and check for proper
cooling.
14. Clean wall and counter surfaces.
15. Replace batteries, if necessary, and check out
electrical system to make sure all lights and
electrical components operate.
16. Check tires for proper cold inflation pressure.
See Vehicle Certification Label in
Introduction section.
17. After washing accumulated winter grime
from the vehicle, it is important to carefully
inspect the seams and sealants for separation
or cracks that may have appeared around the
window frames, vents, and any other joints.
See Sealants – Inspection and General
Information at the beginning of this section.
Re-sealing is quite simple and the material is
quickly and easily applied. Appropriate
compounds are available from your dealer.
See Sealants – Recommended Application
page in the Supplement Manual provided in
your InfoCase.
Also inspect weather seals around doors, etc.,
and if necessary, have a dealer replace
immediately.
Ice Maker Start-Up
–If Equipped
1. Close all drain valves.
2. Turn the water supply on.
11-10
NOTE: Before turning the water supply on,
assure that the water faucet filter is in
place and that the water shut-off valve
(typically located inside galley cabinet
beneath sink) is OPEN.
3. Be sure the ice bin is in place and the
automatic shutoff arm is down.
4. Let the refrigerator cool down to ice making
temperature. Remember, this can take up to 24
hours.
5. Let the ice maker cycle and dump the first
batch of ice.
CHASSIS SERVICE AND
MAINTENANCE
Consult the appropriate sections in your
chassis manual for specific information
regarding operating safety, service
recommendations, and maintenance schedules
for the chassis section of your motor home.

Advertisement

Table of Contents
loading

Table of Contents