Installation Steps - Syscom Video NCT-2211 Quick Installation Manual

•

Installation Steps

Follow these steps to install the network camera on your local network (LAN):
1. Check the package contents against the list below.
2. Connect the Network Camera. See page 3.
3. Set an IP address. See page 5.
4. Set the password. See page 7.
• Package Component
The system comes with the following components:
Cube Camera Installation CD Installation Guide
• Contents in the installation CD
1. The Network Camera User's Manual
2. The SmartManager User's Manual
3. The Syscom Virtual Management System User's Manual
4. The SmartManager Installation software
5. The Syscom Virtual Management System Installation software
Note: Check your package to make sure that you received the complete system, including all
components shown above.
• Front View
[NCT-2211/NCT-2221]
Quick Installation Guide
Stand Clamp
3
Adaptor