Utility Menu - Sony DWR-R02D Operating Instructions Manual

Displaying the Remote Mode
Display whether the receiver is operating in the ST remote
or NT remote mode. (The mode can only be displayed.)
NT: The receiver has recognized the RMU-01 unit and is
operating in NT remote mode.
ST: The receiver is operating in ST remote mode.
SEARCH: The receiver is searching for the remote mode
state.
32

UTILITY Menu

(MODE)
UTILITY Menu
For details on menu operation, see "Basic Menu
Operations" on page 27.
The UTILITY menu includes items related to the basic
receiver settings, including displays.
In this section, the functions included in the menu and their
parameters are explained.
Underlined items are the factory settings.
The following shows the US model display.
Function name
Note
All the items in the UTILITY menu can be set by using the
controls on the receiver channel 1. The UTILITY menu
settings are applied to both receiver channels.
Items Related to Signal Reception
(RF submenu)
Frequency band setting
Selects the frequency band that the transmitter uses.
See "Carrier Frequencies and Channel Steps" on page 44
for factory settings.
Antenna attenuator setting
Sets the attenuator for the antenna input.
This item can be set independently for each of the
ANTENNA IN connectors.
0dB/5dB/10dB
Note
When connecting DWR-R02D units in cascade, set ANT
ATT a/b to "0dB" on any DWR-R02D unit that is not
directly connected to the antenna.
DC power supply setting for antennas
DC OUT)
Sets the power supply for the antennas connected to the
ANTENNA a/b IN connectors.
Item to be set
(BAND)
(ANT ATT a/b)
(ANT