Pioneer AVIC-Z2/XU/UC Service Manual page 317

1
- Removing the dampers (fig. 15)
A
1. Enter the quasi-clamp mode in accordance with the procedure of "Setting the quasi-clamp mode by driving the
loading motor."
2. Remove the module pc board in accordance with the procedure of "Removing the module pc board."
3. Remove the upper frame ASSY in accordance with the procedure of "Removing the upper frame ASSY."
4. Remove the three springs.
5. Remove the CRG SSSY in accordance with the steps 4 and 5 in the procedure of "Removing the CRG assembly."
6. Release each of the three dampers from the clinches as follows:
6.1 By using a pair of pliers, hold the portion A and turn them in the direction B. While making a gap in the portion
C, release the damper from the clinches.
B
6.2 Insert a flat-type screwdriver into the portion D. Slightly raise the plate and release the damper from the
clinches.
7. Remove the CRG motor ASSY in accordance with the steps 2 through 4 in the procedure of "Removing the CRG
motor ASSY."
8. Remove the dampers.
C
D
E
F
28
1
2
C
A A
D
C X - 3 01 6
2
3
B
Fig. 15
3
4
4