Pioneer AVIC-Z2/XU/UC Service Manual page 314

5
- Setting the quasi-clamp mode manually (fig. 11)
1. Remove the module pc board in accordance with the procedure of "Removing the module printed circuit board."
2. Remove the upper frame ASSY in accordance with the procedure of "Removing the upper frame ASSY."
3. Remove the load gear ASSY in accordance with the procedure of "Removing the load gear ASSY."
4. While pulling the clamp lever toward the front side, pull the fixed portion of the load lever R toward the front side
until the mode enters the clamp position.
- Removing the load motor ASSY (fig. 12)
1. Remove the module pc board in accordance with the procedure of "Removing the module printed circuit board."
2. Remove the upper frame ASSY in accordance with the procedure of "Removing the upper frame ASSY."
3. Remove the load gear ASSY in accordance with the procedure of "Removing the load gear ASSY."
4. Enter the quasi-clamp mode in accordance with the procedure of "Setting the quasi-clamp mode manually."
5. Remove the screw. Slide the load motor ASSY to pull it out.
5
6
Slide to remove.
C X - 3 01 6
6
7
Clamp lever
Pull this portion of the
load lever R forward.
Load lever R
Fig. 11
Screw
Fig. 12
7
8
A
B
C
D
E
F
25
8